Datalogic Magellan 1500i - Databar Expanded Reverse Retry

DATABAR EXPANDED ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 195
DataBar Expanded Reverse Retry
Enables/disables the reading of out of specification labels where the last row has been
printed in reverse.
• When enabled, DataBar Expanded Stacked labels that have the last row incorrectly
prin
ted in reverse will be re‐decoded.
• When disabled, DataBar Expanded Stacked labels that have the last row incorrectly
prin
ted in reverse will not be read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
04D800(CR)
DataBar Expanded Reverse Retry = Disable
04D801(CR)
DataBar Expanded Reverse Retry = Enable
DEFAULT