Datalogic Magellan 1500i - Code 39; Code 39 Enable

ENTER/EXIT PROGRAMMING MODE
196 MAGELLAN™ 1500I
CODE 39
Code 39 Enable
Enables/disables the ability of the scanner to decode Code 39 labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
008E00(CR)
Code 39 = Disable
008E01(CR)
Code 39 = Enable
DEFAULT