ENTER/EXIT PROGRAMMING MODE
202
MAGELLAN™ 1500I
Code 39 Length Control
This feature specifies whether variable‐length or fixed‐length decoding will be set for Code
39.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
Code 39 Length Control = Variable Length
Code 39 Length Control = Fixed Length
DEFAULT
To Next Page
Loading...
