Datalogic Magellan 1500i - Code 39 Stitching

CODE 39 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 205
Code 39 Stitching
Enables/disables stitching for Code 39 labels. When parts of a Code 39 barcode are pre‐
sented to the scanner with this feature enabled, the bar
code parts will be assembled by the
scanner’s software, and the data will be decoded if all barcode proofing requirements are
met.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
00D100(CR)
Code 39 Stitching = Disable
00D101(CR)
Code 39 Stitching = Enable
DEFAULT