ENTER/EXIT PROGRAMMING MODE
208
MAGELLAN™ 1500I
Code 32 Start Stop Character Transmission
Enables/ disables transmission of start and stop characters for Code 32.
NOTE
This item is ignored when the advanced feature, Full Label Edit,
is enabled.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
Code 32 Start Stop Character Transmission = Disable
Code 32 Start Stop Character Transmission = Enable
DEFAULT
To Next Page
Loading...
