Datalogic Magellan 1500i - Code 128 Transmit Function Characters

CODE 128 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 211
Code 128 Transmit Function Characters
Enables/disables transmission of Code 128 function characters 1, 2, 3, and 4.
NOTE
Disabled is the recommended setting for all interfaces.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
02C700(CR)
Code 128 Transmit Function Characters = Disable
02C701(CR)
Code 128 Transmit Function Characters = Enable
DEFAULT