ENTER/EXIT PROGRAMMING MODE
212
MAGELLAN™ 1500I
Expand Code128 to Code 39
Enables/disables expansion of Code 128 labels to Code 39.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
Expand Code128 to Code 39 = Disable
Expand Code128 to Code 39 = Enable
DEFAULT
To Next Page
Loading...
