Datalogic Magellan 1500i - Code 128 Minimum Read

CODE 128 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 213
Code 128 Minimum Read
This feature specifies the minimum number of consecutive Code 128 decodes before is
accepted as good read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
006F01(CR)
Code 128 Minimum Read = 1
006F02(CR)
Code 128 Minimum Read = 2
006F03(CR)
Code 128 Minimum Read = 3
006F04(CR)
Code 128 Minimum Read = 4
DEFAULT