Datalogic Magellan 1500i - Code 128 Stitching

CODE 128 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 217
Code 128 Stitching
Enables/disables stitching for Code 128 labels. When parts of a Code 128 barcode are pre‐
sented to the scanner with this feature enabled, the bar
code parts will be assembled by the
scanner’s software, and the data will be decoded if all barcode proofing requirements are
met.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
06A800(CR)
Code 128 Stitching = Disable
06A801(CR)
Code 128 Stitching = Enable
DEFAULT