Datalogic Magellan 1500i - I 2 of 5 Check Character Transmission

INTERLEAVED 2 OF 5 (I 2 OF 5) ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 221
I 2 of 5 Check Character Transmission
Enables/disables transmission of an optional Interleaved 2 of 5 check character.
NOTE
This feature applies only when I 2 of 5 Check Character Calcula-
tion is enabled. This item is ignored when the advanced feat
ure,
Full Label Edit, is enabled.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
008B00(CR)
I 2 of 5 Check Character Transmission = Disable
008B01(CR)
I 2 of 5 Check Character Transmission = Enable
DEFAULT