ENTER/EXIT PROGRAMMING MODE
224
MAGELLAN™ 1500I
I 2 of 5 Length 1
If I 2 of 5 Length Control is set to Fixed‐Length decoding, this feature specifies I 2 of 5 first
fixed length. If I 2 of 5 Length Control is set to Variable‐Length decoding, this feature speci‐
fies the minimum label length.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode,
Set I 2 of 5 Length 1 on page 224 below. You’ll need to cover any
unused barcodes on this and the facing page to ensure that the scanner reads only
the
barcode you intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad in Appendix C that repre‐
sent the desired label length. The selectable range for this option is 02 to 50, even
number
s only. Pad all single digit numbers with a leading zero to yield a two‐digit
entry (02‐50).
4. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
Set I 2 of 5 Length 1
Default setting for this feature = 06
DEFAULT
To Next Page
Loading...
