Datalogic Magellan 1500i - I 2 of 5 Length 2

INTERLEAVED 2 OF 5 (I 2 OF 5) ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 225
I 2 of 5 Length 2
If I 2 of 5 Length Control is set to Fixed‐Length decoding, this feature specifies I 2 of 5 sec‐
ond fixed length. If I 2 of 5 Length Control is set to Variable‐Leng
th decoding, this feature
specifies the maximum label length.
NOTE
When in Fixed Length mode, if Length 2 is set to the value of 00
(zero), then only Length 1 will apply.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode,
Set I 2 of 5 Length 2 on page 225 below. You’ll need to cover any
unused barcodes on this and the facing page to ensure that the scanner reads only
the
barcode you intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad in Appendix C that repre‐
sent the desired label length. The selectable range for this option is 00, or 02 to 50;
ev
en numbers only. Pad all single digit numbers with a leading zero to yield a two‐digit
entry (02‐50).
4. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
0057(CR)
Set I 2 of 5 Length 2
Default setting for this feature = 32 (length = 50)
DEFAULT