Datalogic Magellan 1500i - Codabar; Codabar Enable

ENTER/EXIT PROGRAMMING MODE
226 MAGELLAN™ 1500I
CODABAR
Codabar Enable
Enables/disables the ability of the scanner to decode Codabar labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
008F00(CR)
Codabar = Disable
008F01(CR)
Codabar = Enable
DEFAULT