Datalogic Magellan 1500i - Codabar Start Stop Character Transmission

CODABAR ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 227
Codabar Start Stop Character Transmission
Enables/disables transmission of Codabar start and stop characters.
NOTE
This item is ignored when the advanced feature, Full Label Edit,
is enabled.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
009300(CR)
Codabar Start Stop Character Transmission = Disable
009301(CR)
Codabar Start Stop Character Transmission = Enable
DEFAULT