Datalogic Magellan 1500i - Codabar Check Character Transmission

CODABAR ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 231
Codabar Check Character Transmission
Enables/disables transmission of an optional Codabar check character.
NOTE
Applies only when Codabar Check Character Calculation is
enabled. This item is ignored when the advanced feature, Full
Label Edit, is enabled.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
008C00(CR)
Codabar Check Character Transmission = Disable
008C01(CR)
Codabar Check Character Transmission = Enable
DEFAULT