ENTER/EXIT PROGRAMMING MODE
236
MAGELLAN™ 1500I
Codabar Require Margins
Enables/disables the requirement that quiet zones be present in a Codabar barcode.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
Codabar Require Margins = Quiet Zones Not Required
Codabar Require Margins = Quiet Zones Required
DEFAULT
To Next Page
Loading...
