Datalogic Magellan 1500i - Code 93 Minimum Read

ENTER/EXIT PROGRAMMING MODE
238 MAGELLAN™ 1500I
Code 93 Minimum Read
This feature specifies the minimum number of consecutive Code 93 decodes before is
accepted as good read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
006E01(CR)
Code 93 Minimum Read = 1
006E02(CR)
Code 93 Minimum Read = 2
006E03(CR)
Code 93 Minimum Read = 3
006E04(CR)
Code 93 Minimum Read = 4
DEFAULT