Datalogic Magellan 1500i - MSI Number of Check Characters

ENTER/EXIT PROGRAMMING MODE
244 MAGELLAN™ 1500I
MSI Number of Check Characters
Specifies number of MSI check characters to be calculated and verified.
NOTE
Check characters are always modulus 10.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode below representing the desired number of MSI check characters to
be c
alculated and verified. You’ll need to cover any unused barcodes on this and the
facing page to ensure that the scanner reads only the barcode you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
021700(CR)
MSI Number of Check Characters = 1
021701(CR)
MSI Number of Check Characters = 2
DEFAULT