Datalogic Magellan 1500i - MSI Check Character Transmission

MSI ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 245
MSI Check Character Transmission
Enables/disables transmission of optional MSI check characters.
NOTE
This feature applies only when MSI Check Character Calculation
on page 243
is enabled. This item is ignored when the advanced
feature, Full Label Edit, is enabled.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
00BE00(CR)
MSI Check Character Transmission = Disable
00BE01(CR)
MSI Check Character Transmission = Enable
DEFAULT