Datalogic Magellan 1500i - MSI Length 2

MSI ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 249
MSI Length 2
If MSI Length Control is set to Fixed‐Length decoding, this feature specifies MSI second
fixed length. If MSI Length Control is set to Variable‐Length decoding, this feature specifies
the maximum label length.
NOTE
When in Fixed Length mode, if Length 2 is set to the value 00
(zero), then only Length 1 will apply.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode,
Set MSI Length 2 on page 249 below. You’ll need to cover any
unused barcodes on this and the facing page to ensure that the scanner reads only
the
barcode you intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad in Appendix C that repre‐
sent the desired label length. The selectable range for this option is 00 (meaning
ignor
e this length), or 04 to 16. Pad all single digit numbers with a leading zero to yield
a two‐digit entry (00, 04‐16).
4. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
00CC(CR)
Set MSI Length 2
Default setting for this feature = 10 (length = 16)
DEFAULT