STANDARD 2 OF 5 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
257
Standard 2 of 5 Length 2
If Standard 2 of 5 Length Control is set to Fixed‐Length decoding, this feature specifies Stan‐
dard 2 of 5 second fixed length. If Standard 2of 5 Length Control is set to Variable‐Leng
th
decoding, this feature specifies the maximum label length.
NOTE
When in Fixed Length mode, if Length 2 is set to the value of 00
(zero), then only Length 1 will apply.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode,
Set Standard 2 of 5 Length 2 on page 257 below. You’ll need to cover
any unused barcodes on this and the facing page to ensure that the scanner reads
on
ly the barcode you intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad in Appendix C that repre‐
sent the desired label length. The selectable range for this option is 1 to 50. Pad all
single digit
numbers with a leading zero to yield a two‐digit entry (01‐50).
4. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
Set Standard 2 of 5 Length 2
Default setting for this feature = 32 (length = 50)
DEFAULT
To Next Page
Loading...
