Datalogic Magellan 1500i - Data Matrix; Data Matrix Enable

DATA MATRIX ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 259
DATA MATRIX
Data Matrix Enable
Enables/disables the ability of the scanner to decode Data Matrix labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
010000(CR)
Data Matrix = Disable
010001(CR)
Data Matrix = Enable
DEFAULT