ENTER/EXIT PROGRAMMING MODE
262
MAGELLAN™ 1500I
GS1 Datamatrix Enable
Enables/disables the ability of the scanner to decode GS1 Datamatrix labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
DEFAULT
GS1 Datamatrix disabled
GS1 Datamatrix enabled
To Next Page
Loading...
