Datalogic Magellan 1500i - QR Code URL Link Enable

ENTER/EXIT PROGRAMMING MODE
274 MAGELLAN™ 1500I
QR Code URL Link Enable
Enables/Disables the decoding of QR codes with a URL link on imagers.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
03A100(CR)
QR Code URL Link = Disable
03A101(CR)
QR Code URL Link = Enable
DEFAULT