Datalogic Magellan 1500i - GS1 QR Code Enable

GS1 QR CODE ENABLE ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 275
GS1 QR CODE ENABLE
This feature controls the ability of the scanner to decode GS1 QR Code labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
047500(CR)
GS1 QR Code = Disable
047501(CR)
GS1 QR Code = Enable
DEFAULT