Datalogic Magellan 1500i - Micro QR Code Length 1, Length 2 Programming Instructions

ENTER/EXIT PROGRAMMING MODE
278 MAGELLAN™ 1500I
Micro QR Code Length 1, Length 2 Programming Instructions
If Micro QR Code Length Control is set to Fixed‐Length decoding, this feature specifies
Micro QR Code first fixed length. If Micro QR Code Length Control is set to Variable‐Length
decoding, this feature specifies the minimum label length.
NOTE
Length 1 is the minimum label length if in variable length
mode, or the first fixed length if in fixed length mode. Length
2 is the maximum label length if in variable length mode, or
the second fixed length if in fixed length mode. Length
includes the barcode's data characters only. Any value >
3700 will be considered to be 3700.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode,
Set Aztec Length 1 on page 281 or Set Micro QR Code Length 2 on
page 278 below. You’ll need to cover any unused barcodes on this and the facing page
to ensure that the scanner reads only the barcode you intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad in Appendix C that repre‐
sent the desired label length. The selectable range for this option is 0001 to 3700. Pad
all nu
mbers with leading zeros to yield a four‐digit entry (0001‐3700).
4. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
042B(CR)
Set Micro QR Code Length 1
Default setting for this feature = 0001
042C(CR)
Set Micro QR Code Length 2
Default setting for this feature = 0E74 (length = 3700)