Datalogic Magellan 1500i - Han Xin Code; Han Xin Enable

ENTER/EXIT PROGRAMMING MODE
282 MAGELLAN™ 1500I
HAN XIN CODE
Han Xin Enable
Enables/disables the ability of the scanner to decode Han Xin labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
053500(CR)
Han Xin Code = Disable
053501(CR)
Han Xin Code = Enable
DEFAULT