ENTER/EXIT PROGRAMMING MODE
290
MAGELLAN™ 1500I
SWEDEN POST
Sweden Post Enable
Enables/disables the ability of the scanner to decode Sweden Post labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
Sweden Post = Disable
Sweden Post = Enable
DEFAULT
To Next Page
Loading...
