Datalogic Magellan 1500i - LED and Beeper Indicators

LED AND BEEPER INDICATORS
302 MAGELLAN™ 1500I
LED AND BEEPER INDICATORS
The scanner’s beeper sounds and its green LED illuminates to indicate various functions or
errors on the scanner. The tables below list these indications. The scanner’s functions are
programmable, and so may or may not be turned on. For example, certain indications such
as the power‐up beep can be disabled using programming barcode labels.
LED
INDICATION
INDICATION COMMENT
Power-on 
indication
Bright green flash
Indicates the scanner has finished all its po
wer up tests
and is now ready for operation.
Good Read
Indication
Bright green flash Indicates a barcode has been read and decoded.
Scanner Ready Constant dim green
The scanner is ready for operation. The LED is also con-
figurable to off when idle and ready for operation
Sleep Mode
Green LED slowly and continu-
ously changes from off to dim to
off.
The scanner is in Sleep Mode. To wake the scanner up,
mo
ve an object in front of its window or press the button
atop the unit. This indication is configurable and may be
programmed to behave differently.
Host Disable
Constant green flash at 1 Hz
(1
00mS on, 900mS off)
The scanner is disabled due to receiving a disable com-
mand from the POS terminal.
Diagnostics
Varies (see "Error Codes" on
page A-303 for more informa-
tion)
The LED can provide diagnostic feedback if the scanner
disco
vers a problem during SelfTest.
Prog. Mode See Host Disable above. The scanner is in Programming Mode.
BEEPER
INDICATION
INDICATION COMMENT
Power On Beep Single beep
The Power-On Beep indication is a configurable feature
which can be enabled or disabled. When enabled, this
beep Indicates the scanner has finished all its power up
tests and is now ready for operation.
Good Read
Indication
Single beep
The good read beep indication is configurable. Options
include: Enable/disable, frequency, duration and volume.
See LED and Beeper Indicators on page 57 for more
information.
Diagnostics
Varies (see
“Error Codes” for
more information)
The Beeper can provide diagnostic feedback if the scan-
ner discovers a problem during SelfTest.
Programming
Mode 
Indications
Varies depending upon the fea-
ture(s) being configured.
The Beeper will sound as programming barcode labels
are scanned, indicating progress during scanner configu-
ration.