ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
31
1D Inverse Read Control
This configuration item is used to toggle inverted label reading for 1D barcodes, for exam‐
ple, a label printed as white on black as opposed to black on white.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
1D Inverse Read Control = Disable
1D Inverse Read Control = Enable
DEFAULT
To Next Page
Loading...
