ENTER/EXIT PROGRAMMING MODE
36
MAGELLAN™ 1500I
Sleep Mode Timer
This feature specifies the amount of time of inactivity (with no label reads) before the scan‐
ner enters sleep mode.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode
Set Sleep Mode Timer below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad in Appendix C to represent
the desired time interval. The selectable range is 000‐255
in 15 second increments.
Pad all numbers with leading zeros to yield a three‐digit entry (000‐255).
4. Scan the Enter/Exit Programming Mode barcode at the top of the page to exit Pro‐
gramming Mode.
Set Sleep Mode Timer
Default setting for this feature is: 5 minutes
DEFAULT
To Next Page
Loading...
