Datalogic Magellan 1500i - Accelerometer Delay to Stationary

ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 39
Accelerometer Delay To Stationary
Sets amount of time the scanner will remain in Scanner Active Mode/Handheld State fol‐
lowing the last valid detected motion.
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode
Accelerometer Delay To Stationary below. You’ll need to cover any
unused barcodes on this and the facing page to ensure that the scanner reads only
the
barcode you intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad in Appendix C that repre‐
sent the desired time interval. The selectable range is 00‐255, in 10 millisec
ond incre‐
ments.
4. Scan the Enter/Exit Programming Mode barcode at the top of the page to exit Pro‐
gramming Mode.
1508(CR)
Accelerometer Delay To Stationary
Default setting for this feature is: 150 mS
DEFAULT