ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
43
ERI Timeout
Specifies the amount of time the External Read Indicator (ERI) signal is held active for a
good read. Sets the ERI timeout duration using hex values from 000 to 255 in increments of
ten milliseconds (10ms or 0.01 seconds).
To configure this feature:
1. Scan the “Enter/Exit Programming Mode” barcode above to place the unit in Pro‐
gramming Mode.
2. Scan “Set ERI Timeout,” followed by the two digits (zero padded) from the Alpha-
Numeric Keypad in Appendix C representing the desired time value.
3. Exit programming mode by scanning the “Enter/Exit Programming Mode” barcode
again.
Set ERI Timeout
Default setting for this feature is:
002 -20mS
DEFAULT
To Next Page
Loading...
