Datalogic Magellan 1500i - Scanner Control Button Options

ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 45
Scanner Control Button Options
Configure the Scanner Control Button to one of the following modes of operation:
• Enable all functions: Volume, tone, diagnostics and reset.
• Enable only volume, tone and reset.
• Enable reset only.
• Disable all button functions
To set the desired Scanner Control Button Option:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
05AF00(CR)
Scanner Control Button = Enable All Functions
05AF01(CR)
Scanner Control Button = Enable Only Volume Tone and
Reset
05AF02(CR)
Scanner Control Button = Enable Reset Only
05AF03(CR)
Scanner Control Button = Disable All Functions
DEFAULT