ENTER/EXIT PROGRAMMING MODE
46
MAGELLAN™ 1500I
Good Read Beep Control
This feature enables/disables scanner beep upon successfully decoding of a label.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
Good Read Beep Control = Disable
Good Read Beep Control = Enable
To Next Page
Loading...
