Datalogic Magellan 1500i - Good Read Beep Volume

ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 49
Good Read Beep Volume
Selects the beeper volume upon a good read beep. There are five selectable volumes, with
each volume increment adding approximately five decibels to the previous level:
•Low •Medium High
• Medium Low • High
• Medium
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
001900(CR)
Good Read Beep Volume = Low
001901(CR)
Good Read Beep Volume = Medium Low
001902(CR)
Good Read Beep Volume = Medium
001903(CR)
Good Read Beep Volume = Medium High
001904(CR)
Good Read Beep Volume = High
DEFAULT