ENTER/EXIT PROGRAMMING MODE
52
MAGELLAN™ 1500I
Object Sense Control
This feature controls the illumination idle. It determines whether the main illumination is
controlled by the Object Sensing system, or alternatively, stays continuously on.
Enable = Illumination is controlled by using Object Sense
Disable =
Normal illumination is used but it goes off during sleep mode / disable mode
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
02FD01(CR)04EA40(CR)04CD09(CR)
Object Sense Control = Enable
02FD00(CR)
Object Sense Control =Disable
DEFAULT
To Next Page
Loading...
