Datalogic Magellan 1500i - Reading Illumination Duration

ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 53
Reading Illumination Duration
This feature specifies how long the illumination stays on after a label or label segment is
read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
04EB14(CR)
Reading Illumination Duration = 1 Seconds
04EB3C(CR)
Reading Illumination Duration = 3 Seconds
DEFAULT
04EB64(CR)
Reading Illumination Duration = 5 Seconds