Datalogic Magellan 1500i - Illumination Blank on Beep

ENTER/EXIT PROGRAMMING MODE
54 MAGELLAN™ 1500I
Illumination Blank on Beep
Enable this feature to turn off illumination while sound is playing.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
150E00(CR)
Illumination Blank on Beep = Disable
150E01(CR)
Illumination Blank on Beep = Enable
DEFAULT