INTERFACE TYPE ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
77
RS-232 Interface Selection
This section lists the factory default settings for each of the menu commands for the stan‐
dard RS‐232 in
terface, indicated by a green arrow. Exceptions to default settings for other
interfaces, including Wincor‐Nixdorf, can be found in
Appendix D, Factory Default Settings.
.
Interface Type = RS-232 Standard
Interface Type = RS-232 Wincor-Nixdorf
Great care should be taken to select the correct interface type, since you
can cause damage to the scanner and/or POS terminal by attempting to
change to an incompatible interface. ALWAYS make interface selections
with the host cable DISCONNECTED.
CAUTION
To Next Page
Loading...
