QUICK REFERENCE GUIDE
15
ERROR CODES
If an error is detected, the scanner will sound a long low tone (for three
seconds) and flash its LED, indicating a failure. When this occurs, press
the Scanner button to hear the error code. If it is configured to do so,
the scanner will sound a series of beeps corresponding to the error code
and/or flash its LED simultaneous to the beeps. The table below
describes what these codes mean and what action should be taken for
each.
If the scanner still does not function properly, consult the Product Reference
Guide (PRG) or contact your local supplier or Datalogic Customer Support
Services.
a. Reading of the various bar code symbologies can be independently enabled
or disabled in the scanner.
NUMBER OF LED
FLASHES/BEEPS
ERROR CORRECTIVE ACTION
1 Configuration
Contact Helpdesk for assis-
tance
2 Host Interface
6Main PCB
10 Button Error
11 USB Device
13 CPLD ID
PROBLEM SOLUTION
To Next Page
Loading...
