Enter/Exit Programming Mode Quiet Interval
94 Magellan™ 3450VSi
Quiet Interval
This setting specifies the amount of time to monitor for keyboard activity
before breaking the keyboard connection.
To set this feature:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan the bar code below, Se
t Quiet Interval. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Alpha-Numeric Keypad in Appendix C
that represent the desired time interva
l. The selectable range is 001-100,
which is the interval in 10-millisecond increments. Pad all single and dou-
ble digit numbers with leading zeroes
to yield a three-digit entry (001-
100).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
4. The scanner will automatically exit Programming Mode when the appro-
priate amount of digits
have been scanned
Set Quiet Interval
DEFAULT
Default setting for this feature is:
00A - 100ms
.
To Next Page
Loading...
