Enter/Exit Programming Mode Label ID
110 Magellan™ 3450VSi
Global Mid-Label ID
This feature specifies a global mid-label ID that is added between two bar
codes for transmission.
To set this feature:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan the Set Global Mid-Label ID on page 110 bar code below. You’ll need
to cover any unused bar codes on this
and the facing page to ensure the
scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Keypad on page 461 in Appendix C
that represent the desired mid-label ID
characters; entered as two hex
pairs. A table containing the ASCII Character Set and their corresponding
Hex Values is available in the inside back cover of this manual. ASCII
parameters must be input by scanning a pair of hexadecimal digits for
each character. Thus, to set a two-character value of AB, bar codes con-
taining the digits ‘4’, ‘1’,
‘4’, and ‘2’ must be scanned. The selectable
range for this option is any hex value from 00 to FF.
Complete the programming sequence by sca
nning the Enter/Exit Programming
Mode bar code.
Set Global Mid-Label ID
DEFAULT
Default Label ID for this symbology is:
00 = No Global Mid-label ID
To Next Page
Loading...
