Enter/Exit Programming Mode EAN-8/Jan-8 Both Guards Substitution
138 Magellan™ 3450VSi
EAN-8/Jan-8 Both Guards Substitution
Enables/disables the ability of the scanner to find an EAN/JAN8 guard pattern
in cases where the EAN/JAN8 margin makes the guard look like a character.
To set this feature:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan either the enable or disable bar code below. You’
ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by
scanning the Enter/Exit Pro-
gramming Mode bar code.
DEFAULT
EAN-8/JAN-8 Both Guards Substitution
= Disable
EAN-8/JAN-8 Both Guards Substitution
= Enable
To Next Page
Loading...
