DataBar Limited 2D Component Enable Enter/Exit Programming Mode
Product Reference Guide
173
DataBar Limited 2D Component Enable
This feature controls if a 2D label component be decoded when a Databar Lim-
ited base label is decoded.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan either the enable or disable bar code below. You’
ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
DEFAULT
Databar Limited 2D Component = Disable
Databar Limited 2D Component = Enable
To Next Page
Loading...
