Datalogic Magellan 3450VSi - Code 39 Start Stop Character Transmission

Enter/Exit Programming Mode Code 39 Start Stop Character Transmission
184 Magellan™ 3450VSi
Code 39 Start Stop Character Transmission
Enables/disables transmission of Code 39 start and stop characters.
NOTE
This item is ignored when the advanced feature, Full Label Edit, is
en
abled
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan either the enable or disable bar code below. You’
ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
DEFAULT
022400(CR)
Code 39 Start Stop Character Transmission = Disable
022401(CR)
Code 39 Start Stop Character Transmission = Enable