Datalogic Magellan 3450VSi - General Scanner Features; 1 D Double Read Timeout

Enter/Exit Programming Mode 1D Double Read Timeout
12 Magellan™ 3450VSi
SCANNING FEATURES
1D Double Read Timeout
The 1D Double Read Timeout feature specifies the minimum allowable time
which must pass before reading the same 1D label again (e.g. two identical
items in succession).
To set the Double Read Timeout:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming
Mode bar code.
NOTE
004D1E(CR)
1D Double Read Timeout = 300ms
004D28(CR)
1D Double Read Timeout = 400ms
DEFAULT
004D3C(CR)
1D Double Read Timeout = 600ms
004D50(CR)
1D Double Read Timeout = 800ms
If the incidence of multiple reads is not acceptable, increase the
Double Read Timeout setting to a higher value.