Datalogic Magellan 3450VSi - I 2 of 5 Check Character Transmission

Enter/Exit Programming Mode I 2 of 5 Check Character Transmission
210 Magellan™ 3450VSi
I 2 of 5 Check Character Transmission
Enables/disables transmission of an optional Interleaved 2 of 5 check charac-
ter.
NOTE
This feature applies only when I 2 of 5
Check Character Calculation
is enabled. This item is ignored when the advanced feature, Full
Label Edit, is enabled.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan either the enable or disable bar code below. You’
ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
008B00(CR)
I 2 of 5 Check Character Transmission = Disable
008B01(CR)
I 2 of 5 Check Character Transmission = Enable
DEFAULT