I 2 of 5 Length 2 Enter/Exit Programming Mode
Product Reference Guide
215
I 2 of 5 Length 2
If I 2 of 5 Length Control is set to Fixed-Length decoding, this feature specifies
I 2 of 5 second fixed length. If I 2 of 5 Length Control is set to Variable-Length
decoding, this feature specifies the maximum label length.
NOTE
When in Fixed Length mode, if Length 2 is set t
o the value of 00
(zero), then only Length 1 will apply.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan the bar code, Set I 2 of 5 Length 2 on page 215 below. You’ll need to
cover any unused bar codes on this and the f
acing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Alpha-Numeric Keypad in Appendix C
that represent the desired l
abel length. The selectable range for this
option is 00, or 02 to 50; even numbers only. Pad all single digit numbers
with a leading zero to yield a two-digit entry (02-50).
4. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Set I 2 of 5 Length 2
DEFAULT
Default setting for this feature = 32
To Next Page
Loading...
