Enter/Exit Programming Mode I 2 of 5 Stitching
216 Magellan™ 3450VSi
I 2 of 5 Stitching
Enables/disables stitching for I 2 of 5 labels. When parts of an I 2 of 5 bar code
are presented to the scanner with this feature enabled, the bar code parts will
be assembled by the scanner’s software, and the data will be decoded if all bar
code proofing requirements are met.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and
the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
DEFAULT
I 2 of 5 Stitching = Disable
I 2 of 5 Stitching = Enable
To Next Page
Loading...
